answersLogoWhite

0

There are 3 main bolts not the top of the dash two are under the speaker panels, lift them up as well as on in the middle lift all panels up they just clip in. Next you will have to remove the headunit speedometer and front face off your climate control system, there will be screws here find them not too hard disconnect everything even the control wire for the fan. Remover the faces off the air ducts they are screwed and clipped in. There is screws holding the glove box in that act as a support so you will have to remove these as well. Under the ash tray there will be two support studs take them out. The steering wheel will probably have to come out too. Don't expect it to come out easily because it won't just make sure everything is disconnected first.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you remove the dashboard in a 1991 Honda Civic?

The dashboard on a 1991 Honda Civic is held on by several screws. Loosen and remove all of the screws. Then proceed to pull the dash out.


How do you remove the dashboard of a 1991 Mercedes Benz g class?

The 1991 Mercedes Benz dashboard is held in place with eight retaining bolts and 12 retaining clips. Remove the retaining bolts and pry outward on each retaining clip.


How do you remove the fuel shut off chip located in the dashboard on a 1991 Camaro RS?

There is no such thing.


How do you remove step by step the dashboard of a 1991 Acura Integra?

To remove the dashboard of a 1991 Acura Integra, start by disconnecting the battery to ensure safety. Next, remove any screws and fasteners securing the dashboard, typically found in the glove compartment, around the instrument cluster, and under the steering column. Carefully detach the dashboard from the vehicle, paying attention to any electrical connections, such as those for the gauges and climate controls. Finally, gently lift the dashboard out, ensuring not to damage any surrounding components.


Where is computer Volvo 240 1991?

It is located on the firewall in the passenger's footwell. You have to remove the trim panel under the dashboard to see it.


How do you reset the brakelamp light on the dashboard - Honda prelude 1991?

reset the brakelamp light on the dashboard - Honda prelude 1991


How do you remove the dash board on a 1991 Mercedes Benz 190-E?

The 1991 Mercedes-Benz 190 dashboard is held in place with six retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on each retaining clip.


Is there a filter in a 1991 Triton carburetor?

If you are referring to a Ford, there is no carburetor. It is fuel injected.


Do you have a diagram on how to remove a dashboard of a 1993 dodge dynasty need help?

Dashboard RemovalIf its anything like the 1991, all you do is pull out the wood paneling with your hands; should come out very easily. This will reveal all of the Phillips head screws you'll need to take out to remove the black pieces.


How to Replace heater actuator 1991 Oldsmobile Silhouette?

To replace the heater actuator on a 1991 Oldsmobile Silhouette, first, disconnect the negative battery terminal for safety. Then, remove the dashboard panels and any necessary components to access the actuator, which is typically located behind the dashboard near the heater core. Disconnect the electrical connector and remove the screws holding the actuator in place. Install the new actuator by reversing the steps, ensuring everything is securely fastened before reassembling the dashboard.


How do you change the dashboard lights on a 1991 Beretta 2.2?

== ==


Where is the pass-key module located on a 1991 Camaro?

It is conveniently located on the passenger side forward surface of the defrost air distributor. To access it, remove the dashboard cover, remove the air conditioner controls and radio, remove all right side lower dashboard fasteners, noise deadening panels, etc, pull dashboard assembly away from firewall, rotate defrost air distributor slightly clockwise, and you can reach in and remove the module (grey) with a 7mm open end wrench this guy is exactly right.