try a screwdriver
what steps are required to remove the inside door panel on a 1997 Chevy Malibu.
remove the window handle, remove screws from armrest, remove the inner door handle and the screw on the lower rear of the door panel, lift the panel upwards to remove from the slots along the bottom of the door.
Using a screw driver, remove the screws and the clips from the door panel. Gently pull the panel away from the frame, and remove any wire connectors. Then pull the panel the rest of the way off.
No. To remove the widow its easiest to remove the outside panel
You can see the blueprint of the door on a 1997 Grand Marquis/Crown Victoria at the related link below. This will aid in the removal of the panel.
Carefully
You will need to remove the door panel of your 1997 Chevrolet Corvette. When the door panel is removed the mirror retaining bolts will be visible. Tighten the mirror retaining bolts.
Hi, The power control unit on the door panel have clips that will sinmply pop out with a screwdriver exposing a few door panel to body screws. Remove these and the rest of the panel has the same clips.Simply pop them out.Best bet is to replace them after you remove the panel to get a nice tight fit.You can get them from any local parts store. John Brissette
The inside door panel cannot be removed; instead, to get to the inner workings of the door remove the OUTER panel. Lift the outer door handle to expose the pins that hold the outer handle to the door mechanism. Then press out the pins and remove the handle. Then remove the screws around the perimeter of the door that hold the outer panel. The panel should lift off, exposing all of the inner workings, then you can verify that the inner panel does NOT come off.
The rear door panel is held in place by eight retaining clips into screws. Remove the screws near the door handle. Pry outward on each retaining clip. The rear door panel will come off.
Remove the screws in the door panel.
how do i remove the rear door panel of a 190 e?