Want this question answered?
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
Two drive belts on the 93-97 altima 2.4.
3 drive belts on both the 4 and 6 cyl. + timing belt on 3.3 v6
Not many some where around 20-30mpg, Alot depends on your right foot and were you drive
The Nissan 200SX was produced in the United States and Canada from 1984 to 1998. One can search for used car dealers which have the 200SX in stock on AutoTrader. Once the desired car has been located, a test drive can be arranged with the dealer who is selling it.
Yes you can remove it and still drive the truck......
On 4th generation Nissan Sentras (1995-1999), as well as almost all front-wheel drive cars ever made, the belts are on the right side of the engine, almost against the right side of the engine cavity.
First of all, they are the same as the fan belts on any other car. The fan belt(s) are the serpentine drive belt(s) that turn your fan and other accessories (like alternator, compressor, power steering) They are often referred to as serpentine belts, drive belts, and accessory drive belts. The are located on the outside of your engine, driven by the main pulley (crankshaft pulley). R. Mesyef
How to remove Altenator on Nisasan titan 5.6 4 wheel drive
how to remove front rotors on 2003 Nissan fronter 4 wheel drive pick up
Reference: http://www.fnd4pth.com/R50/FSM/1999/lc.pdf (Pages 9 and 10) 1. Drain Coolant from Drain Plugs on both sides of cylinder block and radiator. (Refer to MA Section "Changing Engine Coolant" in the Factory Nissan Service Manual.) 2. Remove Radiator hoses (upper AND lower) and fan shroud. (Refer to "Radiator.") 3. Remove Drive Belts. (Refer to MA section "Checking Drive Belts.") 4. Remove water pump pulley. 5. Remove crankshaft pulley and front (upper and lower) belt cover. Refer to EM section "Timing Belt." 6. Remove water pump.
The life of serpentine and drive belts depends on the application, belt component quality and them being free of fluid contamination. New belts can often last 50-100,000 miles. However, it is always recommended to preemptively replace hoses at or before the manufacturer suggested mileage.