remove the door panel screws, the door handle, the armrest bolts behind the plastic plugs, the and use a molding tool to pry the plastic clips from the door, also disconnect the electrical connection. Last note, the motor is riveted in so you'll have to drill them out.
your problem might the hidden screw on the bottom of the door in the carpet. It is in the corner toward the back of the door.
Begin by removing the inside door panel. Remove the wiring harness from the electric window regulator. Remove the window regulator retaining screws.
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
I have a drivers side (front) speaker that went out. I think the problem is a speaker connection. How do I remove the window crank (not power windows) and then the whole inside panel?
Its not really a tough job. Once you have removed the panel, you will see what you have to do. Just be careful of all the wires.
Remove the 1997 Chevrolet Suburban drivers side door panel. The window mechanism will be visible. Place the new window into the window track. Secure the window to the track.
Electric or manual?
How to repair power window in 2000 Ford Ranger passenger window will not work with either drivers button or passenger button the relay does not make any clicking noise either What is wrong?
If it is electric windows it is the motor which needs replacing or it could be the regulator
The two way switch in your console is dirty. Remove it, disassemble, clean the contacts and reinstall.
the easy way is to remove the door panel and cut the regulator cables on both sides of the motor then raise the window and wedge a stick under the window to hold it up
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
See the link here to learn how to remove the window switch assembly (steps 1-3)... http://www.autoclinix.com/Mercury/Front%20Speakers2.htm