Just wait and it will fall off by itself.
Try prising the front outwards and sliding the trim backwards. They all seem to fall off because they gradually move backwards because the old clips become brittle. Then they fall off.
I have tried new clips but the front ones are different. Anybody know of a supplier apart from Pug?
To install an exterior door handle on a Cherokee Jeep, first remove the window crank handle and the three screws in the inner door trim panel. Second, remove the inner door panel from the door using a trim stick and take off the vapor barrier inside the door. Third, remove the nut on the rear of the door handle, position the exterior door handle, and secure in place.
Check out this video: http://www.youtube.com/watch?v=whOOsv_EA8s
take screws out and pull door trim off
Hardi-plank or cedar last the longest without rotting.
It depends on the year of Mini. Often its quite simple.
The inside door trim is held in place by several retaining clips. Pry outward on each retaining clip to remove the trim.
You have to take the inside door trim out of the door, then there will be some bolts on the inside of the door remove the nuts and your door latch will come out.
remove the inner door panel, you can access the bolts from the inside of the door.
Which door handle? Though, I think they are all similar in that you must remove the plastic interior on the inside of the door first to get access to the inside of the door. You then unbolt the trim panel to remove it. I just replaced the rear handle on the Sienna and I know the rear works that way for certain. Removed the interior plastic panel (first had to unscrew and remove the two handles on the inside of the rear door, then the entire plastic panel just pulled right off). There were 3 bolts holding the exterior handle trim piece to the Sienna. Unbolted those and the trim popped off. Took me about 15 minutes to take the door apart, replace the handle and put all the pieces back together.
It will not take long at all to remove door trim from a Renault Menage. All you have to do is remove the bottom 10 mm bolts on the door, un-clip the door lights, undo the plastic trimming from the clips, unscrew the door cover and then remove all trimming.
The exterior door handle on a Ford Fusion is replaced by first removing the inner door trim, retaining bolts, and window knob. The door handle can then be unbolted from the frame and a new one put in its place.
Remove the door bezel.Remove the window switch.Remove the door pull trim bezel.Remove the 2 7MM bolts behind the door pull trim bezel.Using a door panel tool, you should be able to remove the plastic clips behind the door panel.