Under the steering wheel are four screws. The two on top are normal screws and the bottom screws are screws with plastic anchors. Remove all four then remove the panel they where holding in place. Next you have to remove the whole dash board that covers the vents, radio, etc. Its held in place by plastic latches behind it near the sides. Do not force it or you will crack the dash or break the latches. You might have to lower the steering wheel to get it completely off. After that all you have to do is unscrew the radio. Biggest pain is getting the dash off without cracking anything.
Begin by removing the decorative cover from your 1990 Chevy Caprice factory radio. Remove the radio retaining screws. Remove the wiring harness and the antenna cable from the back of the radio.
Remove the retaining cover to your 2005 Chevy Malibu radio. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable.
My 1993 Chevy lumina did the same thing i ended up having to get a new battery it turns out my factory radio was the problem : - )
To install a Cobra CB radio in a 2010 Chevy Lumina, first disconnect the battery cables. Then mount the CB box and then power the CB radio. Then mount the antennae.
I have Lumina car and protested that the battery replaced.Now the radio wants code please help.model.92075550serial no 334000493.5.sameer_alal@yahoo.com
hfgtytbeud
remove bezel that covers radio and hvac controls, two ten millimeter bolt hold it in, unhook wiring pack(s) and antenna wire.
Remove the cover from your 1986 Chevy Cavalier radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
no
How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck
Begin by removing the decorative radio cover from your 1981 Chevy Corvette radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
Remove the retaining cover from your 1994 Chevy S 10 pickup truck radio. Remove the radio retaining bolts. Slide the radio out. Remove the wiring harness and the antenna cable from the back of the radio.