This is all there is to it: Remove the two bolts just under the lip below the radio deck (just above the air conditioning controls). Then slip your fingernails or a flathead screw driver beneath the black encasing that shields the deck, air cond. controls, and the two vents. Once you pull off the encasing, the deck should come out with it. Take a flathead screw driver and undo the two clips that are holding the deck (one on each side). The deck should now slide out of the encasing through the front away from the dashboard. Unplug the wires and there you go!
how can i remove stereo from honda crv 1997?
there is definitley a 1997 model forester - i have one myself!!! im about to rembove my stereo aswell so if i find anything out il let you know..... do you know the factory speaker sizes by any chance?
You have to remove the panel which goes around the stereo and compartment. You will see four screws which are holding the holder with the stereo and compartment. Remove the screws and take out the holder. You might need to disconnect wire harness and the antenna before you will be able to pull the holder out. The stereo is sitting on 2(4) screws which keep it in the holder.
On a 1997 Ford Explorer, the stereo amplifier is located above the rear wheel on the passenger side. It can be accessed by removing the side panel.
if your not going to use the old factory stereo, take it apart and you will find that the circit board is labled where it plugs in. Or go to your nearest stereo shop and get a wiring harness for $20.
I don't have a answer I'm asking you
Christmas in Stereo was created in 1997.
go to allexperts.com they will help you on this
On a 1997 Explorer, in location # 20 of your fuse panel, there is a 7.5 amp fuse for the radio, and in location # 29 there is a 10 amp fuse for the audio system.I'm not sure if there also is a fuse on the back of your radio.
Remove your radio it is located on the back it is 7.5amps, it is not with all the other fuses next to the steering wheel.
I AM TRYING TO REPLACE A RACK AND PINION IN A 1997 FORD EXPLORER COULD YOU TELL ME OR GIVE ME A PICTURE ON HOW THE OLD ONE COMES OUT>
What is the wiring diagram for the car stereo on a 1997 Ford thunder bird
On driver side, you will have to remove the steering assembly. With the passenger side you should only have to remove the factory manifold.
because it's a 1997 ford explorer
According to the 1997 Ford Explorer Owner Guide : The engine cooling system ( for all engines ) came from the factory with a 50 / 50 mix of distilled water and GREEN color antifreeze ( meeting Ford specification ESE-M97B44-A )
Go to the fuse box at the driver's side and remove the radio fuse for 3 hours then replace.
Go to Best Buy! they'll put a new one in for $55 plus the stereo plus parts.
How do I change the clock setting on a 1997 Chevy Lumina with a CD stereo system?
try this website http://www.modifiedlife.com/car-stereo-wiring-diagrams-and-car-radio-wiring-diagrams/
I got a 1997 explorer sport with control trac 4wd. its suppose to but it doesnt work.
My 1995 Ford Explorer XLT came from the factory with P235 / 75 / R 15 all terrain tires . Your 1997 should be the same size - check the sticker on the end of your drivers door , that will show the original tire size that came on the vehicle
You can get a stereo wiring diagram for a 1997 ford escort premium radio in any store that sells them.
The easiest way to disarm the 1997 Ford Expedition factory alarm is to remove the fuse. The location of the fuse can be found on the inside cover of the fuse box.
no there different