There has to be a minimum of at least four nuts or bolts holding that seat in place. It should be secured at each corner.
two nuts from under the body removed the seat track - easy as pie !
You need to remove the rear seat before you can removed the front. First removed the one screw on the back of the rear seat then removed the two screws on the front of the rear seat. You can not get to the front screws until you remove the rear screw.
There are 2 pins that must be removed.
There are two 14mm bolts along the bottom front of the bench portion of the back seat that should be removed first. After removing the bench portion there are two 10mm bolts on the bottom left and right side and also two 10mm bolts behind the armrest/trunk access door. After removing all four bolts, lift up and out to remove.
To remove the front grill on a 2007 Chevrolet Tahoe the bumper will need to be removed first. After the bumper is removed, take off the four screws and clips holding the grill in place. The grill is then ready to remove.
pull the wheel off, remove the two caliper bolts, remove the caliper and the rotor can be removed
remove cover, unscrew, disconnect
you have to remove trans.after trans is removed remove tork.conv.check bushing in front pump you will find that it is bad
Just unbolt the seat from the floor and pull it out.
Remove slide pin bolts. Then remove caliper. Rotor should slide off the hub.
Front axle half shafts need to be removed also the front diff and the half crossmember has to be removed to give access to pan.
Push back on the front bottom of the bench (takes a lot of pressure) to release clips Lift up to remove bench, this will expose clips or bolts holding the top of the seat in place Remove bolts or clips and push up on the rear of the seat to release upper clips to remove back of seat