there are two bolts you have to turn to loosen the shoes from the drum. located on the backing plate. also there might still be two or three screws holding the brake drum on located where your wheel bolts on. then it is just like any other drum brake job.
you had better check that out thoroughly, it isn't normal for that to happen. Front and rears should be drum brakes, and theres really no valve to malfunction. My first thought is that the cylinders have overextended and cocked sideways locking the shoes against the drum, this could happen if the shoes were extremely worn out, or the assembly was put together wrong. Second thing to check isn't even the brakes, your front axle may be locked. The next time the front brakes are locked up, open one of the brake bleeders up front. If the pressure releases you have a restriction in the hydraulic system such as a pinched brake line or a collapsed brake hose. If you open the front bleeders and the front brakes are still locked up and they are disc brakes, you may have stuck/frozen brake calipers or stuck caliper slide pins.
What came off of the jeep? How does the other side look? Which one fits properly?
feet
Yes
its down in front on passenger side there will be one wire going to it
no... 75' and older are interchangeable... as are '76 and newer. FYI... cj5 and cj7 cannot swap at all.
The Jeep Wrangler replaced the CJ5 in 1987.
For CJ7 1976 - 1981: track width front 51.5, rear 50.0 wheelbase 93.5 (some list 93.4) For CJ7 1982 - 1986: track width front 55.8 rear 55.0 wheelbase 93.5 (or 93.4) for CJ5 1955 - 1971: track width 48.44 wheelbase 80.5 for CJ5 1972- 1983: track width front 51.5, rear 50.0 wheelbase 83.5 All CJ7's used Dana 30 front axle, AMC 20 rear axle CJ5's as well, for 1976-1983
The cj5 is shorter so it wont line up right
Yes , I have a 1979 cj5 which has a rear seat.
The hardtop from a 1963 CJ5 will not fit on a 1973 CJ5. Some people have found that if they put a different windshield on it that it will fit, but then you have to adjust the wipers. It is best to get a top that fits the measurements for the model you have specifically, for best results.
no it won't the body mounts were different