remove all screws then use a butter knife to push taps down under grill.
You have to remove the bumper cover, under bumper, and hood latch cradle. Then the ac condenser can be moved aside. Then remove fans and lines. Then remove radiator.
To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
if the bumper protector is damaged yes, or else the cover will have no suppot
Open the trunk. Remove all the pushpin retainers. Look under the rear fenders.. remove any screws and pushpin retainers. Remove the braces, if any. Look under the bumper cover itself and remove any pushpins. When all these fasteners are removed, the bumper cover should just slide off. If you want to replace the whole bumper (metal and styrofoam included), take it to a pro or grab a service manual.
Take the bolts out remove bummper install new reinstall bolts
REMOVE TWO TOP BOLTS ON HEADLAMP ASSY. THEN REMOVE BUMPER COVER, THATS RIGHT THE BUMPER COVER, THEN REMOVE TWO BOTTOM BOLTS
To remove the rear bumper cover on a 1993 Ford Taurus wagon, the lights need to be disconnected in the rear. Once all electrical connections are disconnected in the rear, remove the taillights and the fuel filler overflow hose. Remove any nuts and bolts holding the bumper cover on. Using needle nose pliers, pop the push pins around the bumper cover upwards. Slowly pull on the bumper to remove it.
* Apply the parking brake raise the vehicle and support it securely on jackstands * Disconnect the negative battery cable and disconnect any wiring that would interfere with bumper removal * From below remove the splash panel below the radiator and bumper * Remove the radiator grille and remove the headlight housings,turn signal lamps and cornering lamps * Remove the headlights and cornering lamps and remove the fasica to fender fasteners then remove the remaining fasteners and the bumper cover taking care to avoid damaging the cover and the fenders * Working under the vehicle remove the bumper beam mounting bolts Note:The bumper beam brackets can be removed from the chassis by removing the nuts from the studs at the back of the bracket or removing the foam inserts to access the front mounting bolts once the bumper cover is removed * Detach the bumper assembly from the vehicle
I need to replace the bumper cover on a Honda accord 98 EX 4door. is there a site where the screws and pags are?
rip it off
,