0
How do you remove the front bumper cover from a Oldsmobile Alero?
Wiki User
∙ 10y ago
there are 6 10mm bolts that hold the bumper. you will have to remove your mudcover. then there are 6 bolts on the inside of the bumper (3 on each side by the wheel) and 2 pins that hold it (by the hood release) these you pry of with a flat screwdriver. after removing these you should be able to remove the bumper
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you remove abs light hand brake light onto Alero?
You can remove the ABS and brake light, from your Oldsmobile Alero, by removing the dash cover. The light retaining nut must be removed. The light will come out.
How do you remove the front bumper from a 2002 Hyundai Santa Fe?
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
How do you remove the rear bumper cover on a 1987 Oldsmobile Cutlass?
This is a relatively easy endeavor. Simply tie a steel cable abound the rear bumper and the other end to a telephone pole. Put the car in drive and floor it. The bumper will rip off allowing much easier access to the bumpuer cover. Next use a sawsall and hack off the bumper cover. Presto, you are done.
Where is the orifice tube n a 2003 Olds Alero and how do you replace it?
it is under front bumper below right headlight.you have to remove plastic cover and there is a union in line coming out of condenser.it is in that union
How do you replace the spark plugs on an Oldsmobile Alero?
on a 2002 olds alero 2.2 4 cylinder ecotec the spark plugs are located on top of the intake, under the cover that gives the engine size,it is possible that yours may also be located under this cover. All you have to do is remove the four bolts on top of the cover and your plugs will be under there.
How do you remove the cover to insert the oil filter on a Oldsmobile Alero?
If its a cartridge style replacement filter(as opposed to a spin on), then simply unscrew the hex-head shaped holder with a crescent wrench...:)
How do you remove the headlamps on a 2000 Volkswagen Jetta?
REMOVE TWO TOP BOLTS ON HEADLAMP ASSY. THEN REMOVE BUMPER COVER, THATS RIGHT THE BUMPER COVER, THEN REMOVE TWO BOTTOM BOLTS
How Much will it cost to replace the rear bumper cover on an Oldsmobile Intrigue?
The average cost for the part to replace the rear bumper cover on an Oldsmobile Intrigue varies between $88.00 and $124.00, depending on the year. The labor cost to replace the rear bumper will vary between $75.00 and $150.00 depending on the repair shop.
How do you remove the rear bumper cover on a 1993 Ford Taurus wagon?
To remove the rear bumper cover on a 1993 Ford Taurus wagon, the lights need to be disconnected in the rear. Once all electrical connections are disconnected in the rear, remove the taillights and the fuel filler overflow hose. Remove any nuts and bolts holding the bumper cover on. Using needle nose pliers, pop the push pins around the bumper cover upwards. Slowly pull on the bumper to remove it.
How do you remove bumper cover from 1996 blazer?
rip it off
How do you remove rear bumper cover for a 2000 Buick Lesabre?
,
How do you remove rear bumper on a 2002 Elantra?
1. If needed raise vehicle and support it on Jack stands 2. Remove the retaining screws in the wheel wells and along the upper and lower edges of the bumper cover. Remove the tail light housings. Remove the rear trim plate and pull luggage compartment trim out for access then remove the remaining bumper cover retaining screws. Remove the bumper bolts 3. On station wagons remove the rear window washer fluid reservoir for access to the bumper retaining bolts. The remaining bumper bolts are accessible from below 4. Pull the bumper and cover assembly out and away from the car
