I am trying to figure this out as well, but just for the passenger side..
on the driver's side.
1.) you need a Torx driver (T-20) to remove the 3 screws in the bottom of the panel and a Phillips for the screw up near the rear view mirror
2.) on the door handle (not the one to open the door, but the one down by the window controls and locks) you will be able to remove the back part of the handle by pulling it towards the door, you may have to wiggle it.
3.) once that is out remove the whole unit slowly and be sure to disconnect the cable for the controls
4.) unscrew the small Phillips screws inside there
5.) pry away at the sides.. you'll hear popping, but no worries, nothing is broken.
6.) pull up to detach the panel from the window ledge.
7.) remove all other teathered cables
There you have it..
HINT: when replacing your panel, roll your window down to reattach at the window ledge or else it will be a long night
To replace the headlight assembly on a 2006 Jetta, remove the front grill. Then remove the headlight assembly by taking off the screws that secure it in place. Replace with new.Ê
remove the door panel
1.Remove the front door trim panel.Remove the speaker retaining bolts.Disconnect the electrical connector and remove the speaker from vehicle. Installation is the reverse.
Remove front wheel, remove caliper from hub, remove small counter sunk screws from rotor then knock off. rebuild in reverse. Hope this helps
6.5 round
You have to remove the door panel, after that you will be able to replace the speaker.
Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker
You need to remove the Interior door panel. From there you can gain access to the speaker and replace it as needed.
You don't need to remove front door panels, the speaker grills come out.
I was just quoted $1,300 to replace front struts only (does not include rear struts.) Jetta GLI 2003 with 120,000+ miles.
Remove the speaker covers. Each speaker cover is held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
remove the a piller trim, they just pull off remove the black trim which goes across below the windshild with a short screw driver remove the screws from the speaker unplug the wire connector put in the new speaker