Chevy Silverado
Nissan Altima
Toyota Sequoia

How do you remove the front door panels to replace the front speakers of a 1993 Nissan Altima?

373839

Top Answer
User Avatar
Wiki User
2009-04-17 23:40:57
2009-04-17 23:40:57

There are 5 or 6 bolts you need to remove; there are three along the bottom of the door, one in the little pocket where you usually pull the door closed and one underneath the window controls, as well as one underneath the armrest. To remove the master window control and the door lock mechanism, use a flat-head screwdriver to pry them out (they are just clipped in, but be careful) and disconnect the wires underneath these control boxes (also just clipped in). There is also a bolt behind a plastic cover underneath the armrest on the door, and the cover can be pried off with a flat-head screwdriver. once you remove the screws, lift the door panel up and the whole piece should come off as one. Once you have the panel off, you have direct access to the speaker and there are 4 bolts around the speaker that will let you replace said speaker. When you put the whole thing back together, have patience putting the panel back on; you have to put the top of the door panel in where the window comes out of the door, and it should fit very snugly. Make sure the door panel is in the same position it was before you took it apart or the bolts won't line up and the whole thing will rattle. Put the bolts back in any order, but make sure that you put the one back in underneath the controls and the one underneath the armrest. There are three on the bottom of the inside of the door. Hope this helps.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Remove door panels.. Unscrew old speakers..Screw in new speakers..replace door panels...ready 2 GO..

User Avatar

To replace the front speakers in a Toyota Sienna the door panels must first be removed. With the door panels removed the speakers will be easily accessible and the mounting screws can be loosen. Unplug the speakers and remove them. Install the new speakers.

User Avatar

Remove the door panels and replace the speakers. They sit in baskets and are simple to replace. We have instructions at our enthusiasts forum. www.trailvoy.com

User Avatar

I recently changed out the speakers (front and rear) on my 1998 Altima and while I was eventually able to do it, it took quite a while to figure it all out. To replace the front speakers, you'll need to pry off the door panels (at least enough so that you can get a screw driver in there). I can't remember exactly what else I removed but be prepared to remove the housing around the door handle, window switches, etc. The back was MUCH more complicated as the speakers are only accessable from inside the car and this requires you to remove multiple interior panels and molding so that you can get under the rear deck. It is confusing at first but once you start the process it becomes clearer. Try to use the Nissan speaker adapters plugs so you don't need to cut wires and mess up the electric system, you can get those from eBay or amazon.

User Avatar

I recently changed out the speakers (front and rear) on my 1998 Altima and while I was eventually able to do it, it took quite a while to figure it all out. To replace the front speakers, you'll need to pry off the door panels (at least enough so that you can get a screw driver in there). I can't remember exactly what else I removed but be prepared to remove the housing around the door handle, window switches, etc. The back was MUCH more complicated as the speakers are only accessable from inside the car and this requires you to remove multiple interior panels and molding so that you can get under the rear deck. It is confusing at first but once you start the process it becomes clearer.

User Avatar

If you remove the panels from the interior of the trunk you should find the bolts that hold the taillamp assembly to the body of the car. Simply remove the nuts and this releases the lamp assembly.

User Avatar

For the front speakers your gonna have to take the door panels off to get to all the wiring and everything and for the back ones you should just be able to take the plastic cover off and replace them

User Avatar

no they will not, you may be able to cut to fit.

User Avatar

You will need to remove the inner panels to gain access.

User Avatar

Unscrew door handles in front first then just pull off door panels carefully unscrew speakers and replace with new.

User Avatar

you will have to take all the panels out to back and pull up the cardboard and there are the speakers

User Avatar

You don't need to remove front door panels, the speaker grills come out.

User Avatar

Pull the inside door panels off and you will see there bolted in the door.

User Avatar

Pull the inner door panels off and the speakers are mounted in the door.

User Avatar

take the door panels off, remove the housing for the Bose speakers, take apart the housing and cut the wires, put in a small speaker to replace the Bose full range speaker. (alternatively, replace the Bose housing with a custom mounting board) put the Bose housing back and the door panels back. cut the wires on the rear deck speakers and install a 6x9 speaker system. replace the CD player. (the original 2ohm Bose speakers burn out players designed for 4 or 8 ohm speaker systems)

User Avatar

Disconnect the battery and let set for 10 minutes so you dont set off the air bag. Remove the kick panels on bothe sides of the center console. Remove the bolt/retainer on the connecter and then remove screws on the monting bracket.

User Avatar

There should be 4 door speakers in a blazer - all of them are 6 1/2" speakers. I do believe you need to pull off the door panels to replace the speakers, I have not done that to my truck yet.. Hope that helps you.

User Avatar

DO NOT ATTEMPT TO REPLACE THOSE SPEAKERS!!! What you have in the back are 4x6 inch speakers, and no 6x9 will not fit. The panels in the back where the speakers are are very very very fragile. Basically there is no way you can replace the without breaking the majority of the tabs or the panel itself. That is one part of that car that cannot be messed with unless you have some replacement panels. I assure you, you will break them. Even if you try to get it done professionaly, i havent seen any installers that will touch them unless you got replacement panels. You dont need to replace them anyway, just get a good set in the front. Its not worth it to dive into that. I was wondering that myself. I went to a local electronics shop, and they have the speakers in the back listed as 4x6.. there would be room for 6x9 but some modding would have to be done. Hope that helps

User Avatar

Remove the door panels and unscrew the grills, then unscrew the speakers

User Avatar

Which speakers? Kick panels, door or behind seats?

User Avatar

See the answer for the 93 model if you're referring to the rear ones. If you want to replace the front ones, you have to remove the door panels.

User Avatar

Both dash and rear panels use 4x6 in speakers

User Avatar

The front door panels have 6 1/2" speakers and the rear speakers are 6x9"


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.