No, the rotor will come off with out the hub. After the brake caliper is off the only thing holding the rotor is rust. Hit between the studs with a hammer and it will come off.
The front brake rotor, on a 2004 Chevrolet Colorado, can be removed by first removing the wheel. Next, remove the brakes. The rotor will slide off
pull the wheel off, remove the two caliper bolts, remove the caliper and the rotor can be removed
There should be 2 screws on the front of the rotor, remove those and the rotor should come right off....you also have to take off the caliper bracket.
Remove the tire and wheel. Remove the brake pads and break hardware. The brake rotor will slide off. You may need to tap the rotor with a hammer.
Warped rotor. Remove and have it turned, or replaced.
Front or rear, remove wheel, remove caliper, remove caliper bracket, remove rotor.
It is located in front of the left front tire. You have to remove the fender liner to access.
to remove the front rotors u must first remove the caliper and caliper frame then remove the nut in the center of rotor rotor should fall off then hope this helps fordtech
front or rear rotor? jack up wheel that needs rotor removed. remove wheel remove brake pads and caliper for back axle, remove axle nut. u will need special socket to remove this nut slide rotor off axle, making sure u dont drop bearings on the ground to remove front rotor on4x4, it is pretty much the same as rear , except you will have to remove locking hub from axle before you can remove axle nut.
The left front speed sensor is electric and does not have a cable. The sensor is accessed by removing the brake rotor.
The 2004 Dodge Durango has 41.5 in. of front leg room.
The 2004 Dodge Durango has 59.3 in. of front shoulder room.