remove wheel remove caliper by removing 2 bolts on back side of caliper.use an old coat hanger or such, to hang caliper so as not to break fluid line with large channel lock pliers, remove dust cap from center of rotor then u need special socket to remove the axle nut. after removing this nut be careful not to drop bearings when you slide rotor of the axle spindle
remove tires and place a pry bar between the rotor and the back plate and strike with hammer or mallet
start by taking the tires off
remove wheel remove brake caliper remove locking hubs special tool required to remove axle nut
to remove brake rotors you need to jack vehicle off ground remove wheels remove brake caliper,these are secured with 2 bolts on back side of calipers next remove axle nut from spindle, and outer bearing slide rotor off axle. dont drop inner bearing instalation is exact opposite
No, the brakes have nothing to do with the drive shaft.
to remove a 6.8 v10 from a f350 2003 do you have to remove front end
No, the 2003 Ford F350 rims will not fit on a 1999 Ford F350.
Yes, the rims off a 2002 Ford F350 will indeed fir on a 1999 Ford F350.
on top of the motor in the front there is a cover ,,its under that you can use a 1/2 inch rachet to remove the lid and ther you will see the filter. there is a lever on the side to drain the bowl
The rotors on a 2003 Ford F350 are replaced by jacking the vehicle up, removing the wheels, taking off the calipers, and removing the bearing caps. The retaining nut can then be removed, the rotor pulled, and a new rotor put in place.
remove rear brake drums
you dont have to take the hub off to change rotors unless you want too but it just makes a mess and adds hours to your rotor change