do the obvious first ,jack,wheel remove ,caliper off , rotor off , next remove the large nut on the end of axle a air gun is nice , then remove the 3 large bolts behind the steering nuckle, the whole hub comes off bearing and all in one piece and must be replaced as one unit - the whole hub must be replaced at one time , hope that helps ,
you dont need to remove hub just remove the caliper and spider washers on studs
You need to remove the head lap it has some scews on the side and on front.
There will be a wire running to a sensor at the front wheel bearings on both sides. No wire to the bearing, no front abs.
How to remove bed rails from a dodge truck
The front axle itself does not need to be removed.
very very carefully
You slowly remove it
Front bearing will drop out when remove from spindle, rear one will need to remove the grease seal then the bearing will come out. To get the races out drive them out by using a long punch and reacing throu the rotor and drive them out from the back side of the race.
no
If its a 96 you need to unbolt the center seat, Then there should be four bolts on the floor.
1 and 11/16 inch
You have to unbolt it from the frame that attaches to the hood of the truck.