0
How do you remove the governor chip from a 1993 Lincoln Mark VIII?
Wiki User
∙ 16y ago
There is no such chip included in the car. Speed is computer controlled. If you are driving a 93-94 model you can purchase a custom burned chip to add to your car which will remove the speed limitation. If you're running a 95 and newer mark, you can either use a chip as you would with the 93-94 models, or you can purchase a hand-held tuner and use it to adjust the programming in your engine computer to allow for higher speeds.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace the alternator on 1993 Lincoln mark viii?
Disconnect the battery, and remove the electrical connection and remove the bolts, and reverse to install.
What Does it mean when the air bag light keeps flashing on a 1993 Lincoln Mark VII?
Lincoln did not offer a Mark VII in 1993.. Lincoln stopped production in 1992. Then started the Mark VIII in 1993
How do you replace door latch for 1993 Lincoln mark viii?
You have to remove the inside door panel to get access to the door handle nuts.
Will the front seats from a 1994 Lincoln mark 8 fit in a 1993 Lincoln mark 8?
Yes they will
How do you jack up your 1993 Lincoln mark VIII?
go to markviii.org. they have a answer for almost anything with the lincoln mark viii
In what year did the Lincoln Mark xiii come out?
There is no LincolnMark XIII (13). There is however a Lincoln Mark VIII which is a Lincoln Mark 8. If this is what is meant that model car first debuted in 1993.
Where the starter on a 1993 Lincoln mark 8?
Under the trunk
Why is 1993 Lincoln mark VIII overheating?
Bad thermostat?
Where is the thermostat on Lincoln mark 8 1993?
In the thermostat housing
Is the firing order for a 1993 Lincoln mark 8 the same as a 1996 mark 8?
Yes
Where to find the horn relay fuse for a 1993 Lincoln mark viii?
Where to find the horn relay fuse for a 93 Lincoln Mark VIII
How do you replace a multifunction switch on a 1993 Lincoln mark viii?
You have to remove the top and side covers on the steering wheel column, remove I think 4 screws-bolts, disconnect the wire connection, and remove the old switch.
