pull out the little black clip on the front and lift the handle off.
* Remove the shift lever knob,console and shift boot * Disconnect the shift and select cables from the shift control assembly * Remove the large shift cable retainer plate and detach the cables from their bracket on the shift control assembly base * Remove the shift control assembly retaining nuts and remove the shift control assembly
There is a small clip on the side of the leather handle. Pull this clip out, then the shift handle will come off.
There is a staple on the front of the gearshift just below the knob, remove it and lift the shift knob.
Turn it to the left, it screws off.
The 2000 Oldsmobile Alero shift solenoid is located on the top of the transmission. The shift solenoid can be access by removing the inside shifter console.
If your Oldsmobile Alero will not shift into overdrive, the transmission may have froze up. Check the fluid levels to determine if you are low on fluid.
Yes, you can change the shifter handle. Remove the hairpin clip at the front side of the handle and lift the handle from the metal pipe.
yes it is
Their is a small staple in the front of the knob you pull it out with a small screw driver and it should pull right out hope it helped
Are you asking about the shift lever on a column shift car or the console shift handle?
there is a metal u shaped clip pushed in the shifter handle on the front side of handle facing radio/dash.putting car in lowest gear with brake on makes easy to pull out with flat screwdriver.handle lifts off.
You should start from the center by the radio. then there will be screws in you arm console. remove the shift handle this is also held on by a screw probably on the bottom. lift from the rear of the console so you can tell if you still have screws in other places.