0
just did my 99's, remove the two screws-nothing else- then it wiggle out.
Ok, here's the start for this one. Reference is yesterday's frustrating experience. My initial conclusions are to buy a manual or take it to the dealer. I wouldn't want to take it to anyone who has no experience with it. Our's is a 2005. Tried to replace the left front yesterday. The retainer ring was so tight I had to place a long stem scredriver blade against it and hit the handle. Got the ring off and next challenge was the retaining latch holding the electrical connector on the bulb. With the screwdriver I was able to pry it up enough to free the bulb but the only pivot point is painted so use a cloth to protect the paint. I got the bulb out of the housing but there was no way to get it out. 4 electrical connectors were in the way and their latches would not even move. I don't know what they are and didn't want to mess with them. Next attempt was to remove the whole housing. Two silver gray screws on top were easy to remove. The one to the center of the car is about 6-8 inches long, the other about 3. But the fascia holds the assembly in. Tried levering it down but the corners of the headlight housing wouldn't clear it. Looks like the fascia has to be loosened. One note of good news is that I finally found the battery---underneath all of that. Ford headlight R/R never looked so easy.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you remove the headlight assembly on a 2006 Dodge Charger?
You have to unbolt the entire soft bumper and remove. The dealer did this on my car to replace the headlight assembly.
Where is the horn on a 2002 Dodge neon located?
it is behind the passenger side headlight assembly. you will have to remove the headlight assembly to replace it.
Where are the screws to release the headlights of a dodge stratus?
there are two screw right on top of the frame near the headlight itself..those will release the headlight assembly.
Where is the horn on a 2004 Dodge Neon?
Under the passenger side headlight assembly, you have to remove the entire assembly to get to it.
How do you replace front wheel bearing assembly on dodge stratus?
The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.
Diagram of a dodge stratus headlight?
A diagram of your Dodge Stratus headlight can be obtained from most Chrysler dealerships. The diagram can also be found at most auto-parts stores.
How do you change the parking light in your 2004 dodge ram?
you have to remove the headlight assembly 3little bolts
How do you change a headlight on a 2000 Dodge Neon?
Open the hood of the engine compartment. Remove the wiring harness from the headlight. Remove the retaining bolts from the headlight assembly. The headlight unit will come out. Reverse the process to install the new headlight.
Where is the fuel pressure regulator on a 1997 dodge stratus?
Location of the fuel pressure regulator on a 1997 Dodge Stratus
Where can you find the EGR a dodge stratus?
remove air intake box assembly. Egr valve is on left corner of cylinder head.
How do you see a diagram for rear brake assembly for 1999 dodge stratus?
Find diagram of 1999 a Dodge Stratus DOHC engine
Where is the horn located on a 1998 Dodge Stratus?
below right front headlight
