Raise the headrest as high as it will go. At the base of the 2 metal rods that connect the headrest to the seat are small plastic pieces that cover the mechanism that locks the headrest to the seat. On the side of these plastic pieces there is a small hole. On all trucks I have dealt with, the hole was facing the passenger side of the truck. Using gentle pressure on the headrest, raising it upwards, insert a small stiff wire (a straightened out paperclip works, but a stiffer wire is better) into the hole, and push against the catch inside this piece. You can feel the headrest give a bit, and raise up on the side you are working on. Repeat the process on the other side, however, if you relax pressure the headrest can slip back into the locking mechanism. It takes practice to make for a quick removal, but it is not difficult. Just have to push up on headrest and in on release at the same time. If you need to re-install the headrest, if you place the headrest in backwards (face the notches towards the drivers side of the truck) when you need to remove it, it will slide right out. Hope this helps
clockwise
2003 Chevy silverado door panel removal diagram
Remove the tire and wheel from your 2003 Chevrolet. Remove the axle end cap. Remove the wheel bearing nut. Remove the wheel bearing in the wheel seal. Reverse the process to install the new wheel bearing.
It is in the gas tank and to replace it you will have to remove the tank.
Remove the tire and wheel from your 2003 Chevrolet Astro Van. Remove the brake shoe spring and caliper. The brake shoes will come off. Reverse the process to install the new brake shoes.
Remove the 3 screws and pull the ring down -really hard-
you cant
Remove the covers from your 2003 Chevrolet Avalanche speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
Remove the inside door panel from your 2003 Chevy Silverado pickup truck. Remove the wiring harness from your heated side mirror. Remove the mirror retaining bolts. Reverse the process to install the new mirror.
to remove a 6.8 v10 from a f350 2003 do you have to remove front end
Remove screw slide handle forward and pull out from panel. Remove from door operner rod.
you need the special tool its about 30 bucks from snap on