You have to first detach the steering column and then unbolt the dash. Including a bracket that is way up in the middle of the dash. It is an involved job at first but if you have to do it again it can be done in less than 10 min with the whole dash coming out. Then remove the black plastic cover that is in the middle bottom. This is the cover that is over the heater core. When I put my dash back in it was such a hassle to put that bracket back in that I just left it out. I have not seen any problems with leaving it out.
The 1996 Chevrolet blazer gas filter is in the fuel tank. Drain the fuel from the tank. Remove the gas filter retaining bolts. The gas filter will come out.
Your 1996 Chevrolet Corsica cooling system. Remove the water supply line and the water return line. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
If you remove the distributor cap, you will see it bolted on the base plate
with your hands
The exploded view of a 1996 Chevrolet Blazer IFS can be found in the service manual of the vehicle. If you do not have theÊservice manual, it can be obtained from the nearest Chevrolet dealership.
While alone.
According to thie following article, it is 5000# http://www.johnholt-chevrolet.com/testdrive-review.aspx?year=1996&make=Chevrolet&model=Blazer
Inside the fuel tank
The firing order for a 1996 Chevrolet S10 Blazer is 1, 6, 5, 4, 3, 2. The number one cylinder is on the front right as you face the engine.
Remove the wiring harness from the back of your 1996 Chevrolet blower motor. Remove the blower motor retaining bolts. Remove the fan from the blower motor. Reverse the process to install your new blower motor.
I believe it is in your glove compartment there is an access to your flasher.
The computer (ECM).