0
It probably has a locked lug nut that requires a special wrench that should have came with the car. It's small and t shaped. Check the glove box. That is correct. However it is also common to have the Metal Pound on wheel covers as well that would be simply removed by prying on the edges. Only the wire wheel covers will lock.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the firing order on a 88 Buick century 3.8 coil pack?
What is the firing order on a 1988 Buick Century.
How do you replace the alternator on a 1988 Buick Century?
Disconnect the 1988 Century battery. Remove the alternator battery. Disconnect the alternator wiring, then unbolt the alternator. Bolt in the new alternator, then reverse the procedure to finish the installation.
How do you remove the hubcap from a 1988 Mercury Grand Marquis?
1988 Grand Marquis hubcaps have a lock on them. You'll need to buy it. The center panel (with the mercury logo) comes out and you'll see a little opening that is flower shaped. That needs to turn to release the hubcap from the lugnuts.
Can you access the fuel pump on an 1988 Buick Century 4 door from the trunk or floor of back seat?
If there is an access panel, yes. You will find that there is no access panel and that you must remove the tank.
Where is the idle air control valve on 1988 buick century 3.8?
Somebody please answer if you know
What is the firing order for a 1988 Buick Century 3.8?
1-6-5-4-3-2
Where is the number 1 cylinder of a 3.8 1988 Buick Century?
Right front firing order 165432
What kind of refrigerant was used on a 1988 Buick Century?
Factory R-12 Should be conveted to R-134
Where is the fuel filter located on a 1988 Buick Century?
Look along frame rail Follow fuel lines from tank
Why won't my 1988 Buick Lesabre start?
Because its a 1988 Buick LeSabre
How many psi is the fuel pump on a 1988 buick century custom v6 28l fi?
Should be around 40 psi
How do you remove the starter from a 1988 Buick Le Sabre?
Disconnect the - battery cable Raise and support vehicle Disconnect the wiring at top of starter Remove mounting bolts Remove starter
