You need to pinch the plastic sleeve and push from both sides 180 degrees. In then releases the entire connector and plastic hose. (black)
To bleed the hydraulic system for the clutch slave cylinder, there is a fitting on the drivers side of the transmission
It is a 5 speed manual transmission that is operated/shifted by means of a hydraulic operated clutch.
The Ls has a hydraulic clutch mechanism
no adjustment on the 5speed manual transmission with overdrive. hydraulic clutch
Transmission does not have a reservoitClutch if hydraulic has a reservoir
If it is a manual transmission, yes.
Yes , the slave cylinder for your hydraulic clutch is inside the manual transmission bell housing. It slides over the input shaft to the transmission and is bolted in place inside the transmission . To CHANGE the slave cylinder the transmission has to be removed , but the lines to the slave cylinder CAN BE BLEAD from a fitting that extends outside of the transmission bellhousing
no , only with the manual transmission for the hydraulic clutch
The slave cylinder for a manual transmission hydraulic clutch is inside the manual transmission bellhousing
The slave cylinder for the hydraulic clutch on a manual transmission is located inside the manual transmission bell housing
The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing
Not in the transmission , but the hydraulic clutch on a Ford Ranger uses DOT 3 brake fluid