Wiki User
∙ 9y agoRemove the retaining ring from the top of your 1997 Chevrolet 1500 ignition cylinder. Slide the ignition cylinder out and remove the wiring harness.
Wiki User
∙ 9y agoRemove the ignition cylinder retaining ring. Poll the ignition cylinder out. Remove the wiring harness from the back of the ignition cylinder.
You will need to remove the retaining ring at the top of your 2003 Kia ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness from the back of the ignition cylinder.
You will need to remove the retaining ring from the top of your 1975 Chevrolet pickup truck ignition cylinder. Slide the ignition cylinder out and remove the wiring harness. Reverse the process to install the new ignition cylinder.
if it is the ignition lock cylinder, first disconnect the battery, you need to remove the steering wheel ,turn signal switch , etc, then you need to insert the ignition key into the lock cylinder, turn it to the run position,then pull the cylinder out, reverse the operation to install the cylinder,
There will be a pin on the front bottom of the cylinder housing. Turn the key to the on position then push the pin in and pull the cylinder out.
Remove ignition transformer to reach it. There should be 2 camshaft position sensors on the 5.4L engine - visibly on the front right cylinder head and the other visibly on the front of the left cylinder head. Remove ,Replace, then return ignition transformer.
Remove the covers to the steering column, then use a small screw driver and push in tab on bottom of cylinder with key in run position and pull out.
yes you do have to remove lock cylinder:first turn it to the off position and then under column is a hole.Take a pick or coathanger ,bend it straight to go inside hole and press against cylinder release button and pull cylinder out
Remove the retaining ring, from the top of your 1997 Ford Astro ignition lock cylinder. Remove the wiring harness from the back of the ignition lock cylinder.
Remove the retaining ring from the top of your 2000 Mercedes-Benz ignition lock cylinder. Slide the ignition lock cylinder out and remove the wiring harness.
Remove the 2 screws holding the plastic housing around the steering wheel. Remove the top part of the housing; pull down the bottom part as it does NOT come off. Set your ignition to the RUN position. Push in the tab on the underside of the lock cylinder and pull out the old cylinder. Get your new cylinder & set it to the RUN position (or at least out of the LOCK position). Slide your new cylinder in the way the old one came out. Make sure it locks in correctly.
You need to turn the ignition to the on or start position, and then push the retaining pin to remove the cylinder. If you can not turn it, then you can either drill it out, or call a locksmith to come asist you.