How do you remove the ignition lock cylinder on a 1998 Nissan Sentra?
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
How do you remove the ignition key cylinder from a 2003 Kia Optima when a key broke off in the cylinder?
Take the steering column housing off (usually held by 4 screws from the bottom) and remove the starter cap from the back of the ignition cylinder. In a Nissan, the ignition cylinder usually has a T shaped pin which turns the starter. if you can start your vehicle by turning the starter cap with a screw driver, you probably don't have an issue with the starter.
How do you remove the ignition cylinder on a 97 Chevy 1500 WT when it is frozen in the lock position?
The water pump on a 97 Nissan Sentra is behind the timing belt. To replace it you will need to drain the coolant, remove the cylinder head, loosen pulley bolts, drive belts, and water pump pulley. Next, remove coolant hoses, water pump bolts, and finally the old water pump. Reverse directions to replace with new pump.
Changing the spark plugs on an 05 Nissan Sentra 1.8 begins with removing the plastic cover over the plugs, pulling the plug wires, and inserting a deep wall socket into each cylinder to remove the spark plugs. After each plug is removed, a replacement plug is placed into the socket wrench, and re-installed.
I have changed an ignition in one. I used a pneumatic cut-off wheel to cut straight slots in the blank faces of the two bolts that retain the lock cylinder. Then, I used an impact screwdriver to remove the bolts. when you get the new ignition lock cylinder, you can use a large flat screwdriver to re-install the bolts.
Ignition switch and lock cylinder removal 1988 Dodge Ram 50. Disconnect the negative battery cable from the battery. Remove the steering column cover to gain access to the ignition switch/lock cylinder. Using wire cutters, remove the cable band. Remove the bolts that hold the ignition switch/lock cylinder to the steering column. Unbolt and remove the key reminder switch and remove the switch lock cylinder from the steering column.
Can you replace the ignition lock cylinder on a 1994 Pontiac firebird without removing the steering wheel?
how do I remove the key switch from a 1998 ford contour You have to remove the plastic trim around the steering column (behind the steering wheel). Put the key in the ignition cylinder and turn one click. There is a small hole on the side of the ignition cylinder, stick a small screwdriver into this hole and press hard. Pull out the ignition cylinder with the key.