0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is a ignition control module a 1987 Chevy blazer s10?
The ignition module is located in the distributor, under the distributor cap.
Where is the ignition control module on an 1994 s10 pickup located?
Remove the distributor cap and it will be bolted inside the distributor on the base plate.
Where is the drl module located for a 1996 chev s10 pu?
The drl relay is located in the back of the glove compartment.
Will a bad ignition module for a 96 S10 pickup make it stall and what does it do?
Yes, My ignition module was bad, I experienced intermittent stalling. My mechanic replaced and it stopped.
Were is the electronic ignition module at on your 1996 Chevy s10 truck?
If this is the 4.3 engine, it is located on the bracket next to the ignition coil.
Where are timing marks for 2.2 chev s10?
where are the timing gear marks on a 1997 chev s10 2.2 located
Is there a starter swith on s10 95 chev?
You have a starter/ignition switch mounted in the steering column and you have a starter solenoid switch that is mounted to the starter.
How do you install a ignition modulator in a 97 Chevy blazer s10?
my ignition module for a 93 s10 was hld by two small bolts on top of the distributor. don't drop one of them into a storm drain they are not easy to buy.
Where is the ignition control module located on a 1994 s10 pickup?
It is bolted inside the distributor under the rotor on bass plate
Where is ignition module located on a 1996 Chevy truck?
under the distributor cap. it is black plastic and has 2 small screws in it New answer: Sorry but that year did not use an ignition module. It use a crank senser and cam senser. If this is a S10 with the 4.3 L engine, it has an ignition module and it is attached to the bracket that also holds the ignition coil on the passenger side of the engine.
How do you fix the ignition module on a 1990 Chevy s10?
remove distribtrer cap,remove distributer.un plug from pick up coil.remove two bolts holding module..must use dielectric lube supplied with new module...coat entire metal surface before installing new module..distributer must be at top dead center when installing distributer unless you marked posision of rotor prior to removing....
Where can you find a schematic for the ignition control module of a 43 vortec engine in a 1994 Chevy Blazer S10?
Owners manual, positive.
