answersLogoWhite
Starters and Ignition Systems
Chevy Trucks and SUVs
Chevy Blazer S-10

How do you remove the ignition switch cylinder to replace it on a 1976 Chevy truck?


Top Answer
User Avatar
Wiki User
2015-07-15 19:36:56
2015-07-15 19:36:56

Remove the steering wheel then the lock plate then the turn signal switch. You will then see a screw close to the side of the lock cylinder. Remove this screw and pull the lock cylinder out. It takes a special tool to remove the lock plate and you can rent then at some parts stores although they aren't very costly.

Related Questions

User Avatar

how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000

User Avatar

To replace an ignition switch on a 2000 Chevy Blazer remove the lower steering column and dash. Locate the ignition switch and pull the end-clip off the main harness. Remove the mounting screws from the ignition cylinder and replace the unit.

User Avatar

How I can replace ignition switch cylinder from Isuzu Rodeo?.

User Avatar

Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.

User Avatar

The ignition lock switch is found under the steering column on a 2004 Honda Civic. Remove the steering column and ignition switch. Loosen the mounting screws that hold the cylinder in place. Pull and replace the lock cylinder.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.