Remove the bezel from around the radio, this will expose two hidden screws. Remove these screws and about eight other screws to remove the lower dash panel below the steering wheel. Remove the two large bolts and drop down the steering column. The ignition switch is a white module on the top left of the steering column. Remove the connectors along the right and the two screws along the left. Lift up the switch to disengage the mechanical link to the key tumbler to remove. Good luck finding a new module, I couldn't locate one for mine, so I just reconditioned my old one using some contact cleaner.
If you're talking about the ingition cylinder, remove the steering wheel and turn signal switch. Remove the buzzer switch (white plug with a couple wires) located at about 4 o'clock by pulling straight out with a pair of needle nose pliers. This will expose the cylinder retaining screw. Remove the screw, and with the ignition switch in the locked position, pull the cylinder straight out...
Remove steering wheel and signal switch
You can remove the 1999 Cadillac Deville ignition switch by removing the retaining ring. The retaining ring will be at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the back of the switch. Reverse the process to install the new switch.
I had to change the ignition switch on my 89 Cadillac eldorado and belive me it is lots of work!! you need some special tools for taking out the sterring wheel and one for puting it back in. I recomend taking it to the dealer to get it done.sorryAnswerI had to change the ignition switch on my 89 Cadillac eldorado and belive me it is lots of work!! you need some special tools for taking out the sterring wheel and one for puting it back in. I recomend taking it to the dealer to get it done. sorry
It can cause the ignition lock cylinder to not turn. If it turns then the key is not why it will not start. Look into the ignition switch, starter, battery, or connections.
How to remove ignition switch
Referenced from 'Chilton 28540 Deville/Fleetwood/Eldorado/Seville 1990-98 Repair Manual' Page 2-10: "Ignition Module The HEI Module, acting as an electronic ON/OFF switch controls the current flow in the primary winding of the ignition coil. This switching action induces a high voltage in the ignition coil secondary winding which is directed through the rotor ans secondary leads to fire the spark plugs. It is not necessary to remove the distributer from the car. 1. Remove the distributer Cap 2. Remove the rotor" This is the Ignition module. Don't remove or replace unless you understand how and know the procedure for changing.
The 1995 Cadillac Eldorado air conditioning clutch relay switch can be found on the firewall in the engine compartment. The air conditioning clutch relay switch will be on the passenger side of the firewall.
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
you will have take the air bag off if equipp the steering wheel turn signal switch and lock plate
In order to remove the headlight switch of a 1988 Cadillac Eldorado, you must first disconnect the negative cable from the battery and allow time for the capacitors to discharge. Unscrew the headlight switch, remove the wire plugs, and remove the switch itself. Insert a new switch and replace the wire plugs and screws. Reconnect the negative cable and test the new switch.
back of right head
Remove the retaining ring from the top of your 1990 Lexus ignition switch. The ignition switch will slide out. Remove the wiring harness.