0
How do you remove the ignition switch key lock on a 1989 jeep wagoneer?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove the ignition switch on a 1989 Chevy Corvette?
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
How do you change the ignition switch on a 1989 Chevy Blazer S10?
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
How can i replace an ignition switch in a 1989 Oldsmobile cutlas ciera sl?
Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
How do you remove replace a 1989 Vanagon ignition switch?
Here is a link to an illustrated step-by-step procedure for replacting a Vanagon ignition switch: http://carboncow.net/vanagon/projects/ignition_switch.htm
How do you install ignition switch on 1989 Chevy G 10 van?
how do you install new ignition switch on 1989 chevy G10 van?
How can you start a 1989 mercury cougar with a broken ignition switch?
how can you start a '89 mercury cougar with a broken ignition switch?
How do you replace the ignition switch on a 1989 Jeep Waggoner?
you have to remove the steering wheel and the turn signal. this requires special tools that can be purchased or rented cheaply.
How do you remove an ignition lock on 1989 GMC Sierra?
== ==
How do you locate the ignition switch on a ford Bronco II 1989?
If you know where to put the key in, you know where the ignition switch is... Actually, safe to say you should stay away from it.
Is there a reset switch for the ignition on a 1989 Dodge colt gt turbo 1.6 liter?
No.
How do you remove the ignition switch in a 1989 Ford Aerostar?
ok here goes/to remove/rotate lock cylinder to lock position.if equipped with tilt steering remove upper extension shroud.remove ignition switch connector then drill out break off bolts connecting the switch with a 1/8 in drill bit remove the two screws from actuator pin. to install rotate key to run positioninstall switch by aligning holes on switch casting with holes in lock cylinder install break off bolts and tighten until heads shear off. have alot of patience.
How do you remove and replace the ignition coil on a 1989 Toyota Celica?
you suck it up
