you have to remove the steering wheel and the turn signal. this requires special tools that can be purchased or rented cheaply.
Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Here is a link to an illustrated step-by-step procedure for replacting a Vanagon ignition switch: http://carboncow.net/vanagon/projects/ignition_switch.htm
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
how do you install new ignition switch on 1989 chevy G10 van?
how can you start a '89 mercury cougar with a broken ignition switch?
If you know where to put the key in, you know where the ignition switch is... Actually, safe to say you should stay away from it.
No.
you suck it up
It is located by the ignition switch on the right side of the steering column.
you have a short or disconnected wire in the switch. you may need to replace your ignition switch. i have a 89 jeep and it was doin the same thing: it was the ignition module If one of the wires gets disconnected from the ballast resistor it will do the same thing.
LOCKSMITH CHEAP QUICK