* Disable the airbag system * Remove the instrument cluster bezel * Remove the retaining screws and pull the cluster forward * Unplug the electrical connectors and remove the cluster from the car
remove front door panel 1995 Nissan maxima
How do I remove An 87 Nissan maxima gas tank
Remove instrument cluster in a 2003 olds aurora
go to just answers and they will send you a complete diagram with pretty good instuctions. I did it myself and it was right on the money. For a small donation of 15 dollars they will help you out all the way through the procecedure.
Disconnect negative battery cableTilt the steering wheel to its lowest position and remove the instrument cluster bezelRemove the instrument cluster retaining screwsPull the instrument cluster out,unplug the electrical connectors from the backside and the shift indicator from the bottom (automatic trans models) then remove the cluster from the instrument panel
Remove the dash and remove the instrument cluster, the lights are in the back of the cluster.
remove the trim panel around the instrument cluster then remove cluster. On the back of instrument cluster are the bulbs just turn them half a turn and they come right out.
Remove the instrument cluster and replace the bad bulbs. Take the battery cables off!Remove the upper and lower steering colum covers. Remove the four screws on the cover. Tke the screws out of the cluster and turn it over. Replace the bad bulbs. Had to replace the whole cluster on mine as the speedometer and the heat guage were kaput!
what year maxima? please email ttrung1979@yahoo.com In i can tell you how to do it..
Remove the instrument cluster cover. Each instrument gauge is secured separately with retaining screws. Remove the retaining screws from each gauge. Remove the wiring harnesses from each gauge.
twist then pull
# Disconnect the negative battery cable. # Apply the parking brake and block the rear wheels. # Turn the ignition switch to the OFF position. # Shift the gearshift lever to the 1position. # Position the steering wheel in the full-down position. # Remove the two instrument cluster bezel screws. # Separate the instrument cluster bezel from the instrument panel enough to gain access to the electrical connectors. Disconnect the following electrical connectors: # Rear window wiper/washer switch # Rear window defogger switch # Hazard warning flasher switch # Power E-AT switch, if equipped # Security indicator lamp, if equipped # Cruise control ON/OFF switch # Headlamp switch # Remove the instrument cluster bezel with the switches attached. # Remove the four instrument cluster screws and separate the instrument cluster from the instrument panel. # Position the cluster to gain access to the gearshift indicator. Remove the gearshift indicator from the cluster. # Disconnect the electrical connectors from the instrument cluster and remove the cluster. # The installation is the reverse of removal.