0
How do you remove the intake manifold cover on a 2009 Chevy Malibu?
Wiki User
∙ 10y ago
remove the intake, (air cleaner) your going to have to lift the fuel rails, a few bolts and some snaps you pop up, and remove the Power Steering resivor and pump, then you should be good to pull the bolts up... check to see if the bolts were just loose.. dont tighten to much regardless, dont want to lift the threads.. its a little more than what's typeable, look on YouTube
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is the restrictor plate on a Chevy Malibu?
same place all restrictor plates are, intake manifold, but the Malibu doesnt have one u can remove, it is build into the intake so u would need a perormance upgrade
How to replace the Intake manifold gasket on a 1996 Chevy Astro?
Remove the intake manifold retaining bolts from your 1996 Chevy Astro Van. Remove the manifold gasket and clean the surface. Reverse the process to install the new intake manifold gasket.
How do you remove the intake manifold on a 1996 Chevy Tahoe?
by hand :)
Where is the Fuel rail on 2000 Chevy Malibu?
under top plenum on 3.1 engine at intake manifold.
How much does it cost for a Intake manifold gasket on a 1999 Chevy Malibu?
It is between $65-$85 for the gaskets.
How do you remove lifters from A 1998 Chevy 454?
They are under the intake manifold.
Where are the 2 knock sensors on 2003 Chevy silverado 4.8l?
They are underneith the intake manifold. You can not see are get to them until you REMOVE the INTAKE manifold.
What causes a vacuum leak in a 1998 Chevy Malibu?
bad vacuum hoses or leaking intake manifold gaskets.
Where is the thermostat in your 1999 Chevy Malibu 2.4L?
The thermostat on a 1999 Chevy Malibu 2.4L is located on top of the engine, in the intake manifold. It is within its own housing which is connected to the upper radiator hose.
Knock sensor location on Chevy Yukon with 5.3 vortec?
On valley cover plate underneath intake manifold. Must remove intake manifold to get to them.
How many hours to replace lifters in Chevy 350?
It depends on what you have to remove to get the intake manifold off. Once the intake manifold is off it will take about an hour.
Where is the knock sensor located in a 2001 Chevy Tahoe with a 5.3?
There is 2 of them and they are underneath the intake manifold. You will have to remove the intake to get to them.
