Want this question answered?
Under the intake manifold, u need to completely remove your intake manifold to Access it..
The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.
The PCV valve is located on the back, drivers side of the intake manifold in a short, rubber hose. It is threaded into the intake manifold close to the last "N" in Nissan which is imprinted into the intake manifold. It requires a 3/4" wrench to remove it.
remove intake manifold.
I need to remove my glove box on my 2009 Nissan Murano. Where are the glove box pins located?
the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!
There is 2 of them. and they are under the intake manifold. You will have to remove the intake manifold to get to them.
Remove the intake manifold retaining bolts from your 1993 Mercedes-Benz manifold. Remove the old manifold gasket. Clean the surface and put the new gasket on.
BACK SIDE OF ENGINE, UNDER INTAKE MANIFOLD, BOLTED TO TRANSMISSION LEFT OF THE OIL FILTER
Remove the intake manifold, exhaust manifold, and then remove the head.
Any aftermarket shop will be happy to do it for you
Basically you remove the throttle body, fuel rail, and anything else that is plugging into it, then unbolt it. You need to get a shop manual however, because there is a specific bolt pattern you need to use to avoid damage.