The autos do not have a safety switch....They have a sensor located in the trans itself that tells the ecu if its in neutral/park.....I believe its a 3 pin plug going into the trans itself,.....trace it and see where it leads.....You may be able to hook up a toggle switch..
The 1990 Mazda 323 horn relay switch can be found on the front drivers side quarter panel. The relay switch will be on the inside of the quarter panel.
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
The thrust bearings are inside the engine. You must remove crankshaft to replace them.
A bad battery terminal(s) connection, bad ground, bad ignition switch, bad starter.
The carbureted 86-93 Mazda trucks do have a catalytic converter off the exhaust manifold, whereas the fuel injected version does not. If you have the carbed version, and you put on a header (like a pacesetter) to replace the exhaust manifold, then you will get rid of 1 catalytic converter.
park/neutral switch mazda 6 04 is just above bottom gearbox mount !
The neutral safety switch, release switch, or brake switch is bad.
Would not have a neutral safety switch - may have have a clutch safety switch usually located at the upper end of the clutch pedal under the dash area
Would not have a neutral safety switch - may have have a clutch safety switch usually located at the upper end of the clutch pedal under the dash area
Clutch safety switch =- should be on the top of the clutch pedal under dash area Neutral safety switch could be at the lower end of the gearshift handle or at the side of the transmission
neutral safety switch/ or reverse switch faulty thanks. how would i go about replacing the safety switch? is it difficult?
switch is either on side of transmission, or under the dash
Neutral safety switch improperly adjusted or going bad
right side under hood near batt in a box
This is usually known as a neutral safety switch or shift interlock switch.
Check to see if the shifter is not all the way into park. If it is Your neutral safety switch my be inoperative. The remote goes through the body control module to the neutral safety switch. Good luck!
if you look on the transmission, you should see two wires connected to the neutral switch.