Slide the red part of connecter to the side, then squeeze release down and pull off.
You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
The 2000 Dodge Caravan alternator can be changed by removing the alternator belt. Remove the wiring harness from the back of the alternator. Loosen and remove the alternator retaining bolts. Install the new alternator by reversing the process.
the fusible links are in cable harness that go trough the firewall next to the brake power booster you may have to remove some of the harness tape and shielding
You can begin by removing the wiring harness from the back of your 1998 Dodge Grand Caravan alternator. Remove the alternator belt. Remove the retaining nuts. Reverse the process to install your new alternator.
No, you only need to remove the tire to check it's pressure.
Remove the oil pressure sending unit retaining ring. Remove the wiring harness from the sending unit. Poll the sending unit out of the engine.
Remove the glove compartment(just push in on tabs on side) relay is right there just unplug harness and replace
Remove the wiring harness from the 2003 Jeep Liberty pressure switch. Remove the power steering pressure switch retaining screws. Reverse the process to install the new power steering pressure switch.
The power steering pressure switch screws in. Simply unplug the wire harness, unscrew the old switch and screw in the new switch. Plug the wiring harness back in.
This should be done by depressing the lock tabs holding the connector halves together and simply disconnect the door harness from the body harness. Good Luck!
how to remove a starter on 2000 dodge caravan
can you answer it i have a 3 bedroom static caravan but my bedroom is to small can i remove a wall to make extra room