On most cars it just pries out of the door handle. Be careful not to break it.
Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.
If you mean the extra switch on the drivers side power window control it cuts power to the passenger side window switch. Handy if you have kids.
The switch could be bad at the passenger seat. The switch could be bad at the passenger seat.
There is only one fuse for all power windows. If only the passenger side window does not work, the problem is either with the passenger window switch or the motor on that window.
Your switch is bad or the window motor has gone out
NOTE: Anytime the battery terminal has been disconnected, please initialize the driver's door power window and front passenger's door power window after reconnecting the battery terminal. With ignition switch in the "ON" position, do the following: 1. Push down and hold the driver's door power window switch to completely open the window. 2. Pull and hold up the driver's door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination. 3. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions. At this time the power window switch for the passenger's door window should be blinking. 4. Push down and hold the passenger's door power window switch to completely open the window. 5. Pull and hold up the passenger's door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination. 6. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions
Remove the door panel. Remove the switch retainer. Remove the wiring harness. Reverse the process to install the new switch.
The 1994 Chevrolet Camaro power window relay switch can be found inside of the driver side door. You will need to remove the door panel to access the power window relay switch.
you can by pass the switch, get wiring diagram and figuare out wich wires are for window motor you need rolled up, then remove switch and put power to wire that will make motor roll window up
If it won't work from either switch suspect motor or regulator, if it works from one switch then it is most likely the switch.
remove pwer window switch disconnect wires. using another wire, bridge the wires in swith to complete circuit window will go up
main switch is bad