Remove bottom plastic cover in center of dash first and then remove other plastic part that the first peace was attached to. (watch for hidden screws)
To change the front signal light on a 2006 Chevy Express van, remove the bottom plastic cover that runs along the grill. Pull the push pins that hold the light in place. Remove the bulb and replace with new.
The plastic cover will pop off. Then remove bulb.
You remove the plastic cover behind the headlight, there is a plastic connector (two or three pin) remove this, undo the circlip holding the lamp in. Then remove bulb You remove the plastic cover behind the headlight, there is a plastic connector (two or three pin) remove this, undo the circlip holding the lamp in. Then remove bulb
look in the owners manual very helpful book. or remove plastic cover and twist plastic cover where build is
To get to the Malibu's headlamp assembly, first pull up on the two black plastic tabs to remove the headlights plastic cover.After the headlight area cover is removed, there are two tabs that when you pull up on them they will release the headlight assembly.got this from natwilson.com
The mount is located on the drivers side of the vehicle. remove wheel and plastic cover to access.
Purchase a Purolator Cabin Filter for your Impala. It comes with complete instructions. The filter is located below the windshield, passenger side. The black plastic cover must be removed to access the filter. You simply raise the hood and remove 3 plastic clips, and the washer hose from it's holders. This will allow you to remove the plastic cover over the filter.
Open trunk remove 2 plastic push pin remove cover
Before you try to remove the plastic cover, there is a small screw that you have to remove at the bottom of the cover. When you get the cover off, there are two small bolts. The top one was the one that was loose on mine.
You have to remove the entire headlight assembly. Glass cover clips on with plastic clips. Remove and install CAREFULLY as glass breaks easily.
Remove the instrument panel plastic cover. Remove the back cover of the instrument panel. The instrument panel lights will be visible and can be accessed.
Try against firewall on passenger side--may have to remove plastic cover
If it's like my 96 then remove the all-across plastic panel. You might have to remove the headlight piece,(a couple bolts). Then pull out the old bulb. Easy; turn, pull, replace.
how do you remove the pince bolt cover of a 2005 Chevy express van
Under the hood there is a plastic cover that mounts to the firewall. Remove the cover and there should be a couple fuses and a relay. Everything should be labeled.
Remove the black plastic piece with the writing on each valve cover and with a rachet and extension remove the plugs etc.
We have detailed headlight change procedures at our enthusiasts forum www.trailvoy.com
If there is another cover then you can remove it. If the plastic covering is the only cover on the cheese and it is kept off there is a good chance it will go bad earlier then it should.
how to change timing cover gasket on a 1996 chevy lumina
you take it to a dentist
Remove the valve cover
There will be a cover on the end where the arm connects to the motor. If you remove that small plastic cover there is a 13mm nut threaded onto a bolt. If you remove that bolt and other hardware that follows you can easily remove the wiper arm.
Inside that flat cover on the very top of the engine.There are 2 inside that plastic housing,after you remove that assembly.