Want this question answered?
simply remove the phillips head screws holding the plastic seat trim on. The switch will be right behind it. Disconnect the harness plug and remove the two screws holding the switch down. Note: driver and passenger switchs are the same so if need be you can use one for the other.
Assuming the other seat adjustments work, and the switch tests okay, remove the seat, turn it over and inspect the forward/backward mechanism. You will probably find something broken.
All Volvo cars have seat belt. Volvo invented the three point seat belt and has used it ever since.
Move the seat as far forward as possible. Grab the front of panel and pull up while wiggling it. Once the front comes loose you can wiggle the back part out.
1. Remove two plastic covers from rear bottom of driver seat to expose nut & bolt. 2. Unscrew nut on left side of seat rear & unscrew bolt at right rear (holds seat to floor). 3. Unscrew two bolts at front of seat (left & right) on floor. 4. Raise front of seat enough to gain access to two cables. 5. Disconnect two cables by pressing where appropriate to release. 6. Remove seat from vehicle (or slide far enough forward to access screws near switch). 7. Unscrew three screws holding plastic molding that has power seat switch.. 8. Pull plastic molding far enough away to gain access to switch. FINAL: unscrew four screws hold switch to plastic molding. REPLACE SWITCH REVERSE SEQUENCE to replace.
to remove the power seat swithch,this covers about 10 yrs from late 80's to late 90's corvettes. You must remove the seat on the acording side and remove the side cover on the console, the switch will be completely exposed at this time. dont try to unplug it from the harnes " The harnes comes with the switch so you will need to ( carefully ) roll the carpet back and follow the harnes to it's head plug's , there are two " its a bi*ch if you dont know what you are doing but once you have done it a time or two it gets much easier and quicker.. Just remember to take your time and dont damage the console of seat.
To switch out a seat belt usually the seat needs to be removed first. Then it is in most instances just a bolt to be removed.
there should be 4 bolts that hold the seat to the floor. just remove them and if it has power seat dont forget to unplug them.
with the power seat switch on the side of the seat (drivers or passengers side). The same switch that reclines the seat back is used 'up' or 'down' for the headrest.
you need a window switch bank most likely. Can you get it to go up with the button on the door but not from the front seat? If so, you need to pick up a window switch bank. Common Issue.
battery off switch is in the boot next to the aux. power socket. battery on switch under the rear seat behind drivers seat.
Through the trunk under the carpet nearest back seat.