Look at the door panel, the handle/arm rest where the switch is located has 4 long screws recessed into it on the bottom, they will look like deep holes but there are screws inside, remove them. on the door handle, (to open the door from the inside), there is a small screw, remove it. now feel along the bottom SIDE of the door panel itself, there should be four to five screws hidden in the carpeting, remove them, along with screws on the side edges of the doors, remove them. now, after you have removed the peice of plastic at the door handle, leaving nothing but the handle there, it will expose a screw that is attached to the handle of the "armrest" on the door. remove it. after all this is done, pull up, and back on the door, you will hear a snap, that will be the plastic "pop screws" ,its ok, they will pop back into their place after. now your door panel is off, unplug the wire attached to the switch, and push the switch out the top of the "arm rest".
Much easier to use a small screwdriver and insert tip into edge of switch and carefully pry it up and out on both ends of switch. Be very gentle in this procedure and try not to damage switch. Just takes a couple minutes instead of removing the complete door panel and replacing--mtndawg--
check power going to the switch , and power coming out of the switch ,if no power check fuses and wiring for open or shorts , then remove door panel and bench test the motor basically put power to the window motor
blown wire/fuse
Remove the door panel. Remove the switch retainer. Remove the wiring harness. Reverse the process to install the new switch.
The 1994 Chevrolet Camaro power window relay switch can be found inside of the driver side door. You will need to remove the door panel to access the power window relay switch.
you can by pass the switch, get wiring diagram and figuare out wich wires are for window motor you need rolled up, then remove switch and put power to wire that will make motor roll window up
remove pwer window switch disconnect wires. using another wire, bridge the wires in swith to complete circuit window will go up
The 1997 Cadillac power window relay switch can be found inside of the drivers side door. You will need to remove the inside door panel in order to access the power window relay switch.
Remove switch panel and jump wires on switch- if this works bad switch Remove door panel and see if the motor is getting power-if it is getting power, bad motor
A power window relay switch relays the power from the car's battery, to the switch itself, and then to the window motor. When pressing the button inside of the car it allows the power to go from the relay switch to the motor and roll the window up or down.
in the hand part where you close the door theres a screw, take it off, pull the assembly from the top by the window switches, when it comes out the wires will follow, disconnect the harness, and replace with the new power switch. (note this is the drivers side)
remove switch from where it is mounted using a wire , bridge the connections.if switch is bad, it will work the motor while bridged
Tell me if just one window or all of them quit working