in the hand part where you close the door theres a screw, take it off, pull the assembly from the top by the window switches, when it comes out the wires will follow, disconnect the harness, and replace with the new power switch. (note this is the drivers side)
Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.
blown wire/fuse
How do I replace the power window switch on 1977 Corvette coupe
Your switch could be worn out you would have to replace the rocker to the switch or replace the whole window switch console.
The led light in the window switch is not replaceable. It is only serviced with the entire switch.
Do you mean the main switch by the driver or the switch on the door itself?
First test to see if the problem is the switch, wiring, or the motor. Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/test-power-window-motor-and-regulatorThen replace the regulator if the switch and wiring test good. Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator
check power going to the switch , and power coming out of the switch ,if no power check fuses and wiring for open or shorts , then remove door panel and bench test the motor basically put power to the window motor
pry out the control switch and disconnect the electrical connectors.install is reverse.
The switch is burned out. Replace it.
Broken regulator. REplace it. Here's how:http://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator
you must determine weather the switch or window motor is bad and replace.