The bolt has left-hand threads, and requires a lot of torque. Turn counter-clock-wise to loosen/remove the serpentine belt, then use a cheater-bar on your wrench to loosen the pulley-bolt (turning clock-wise).
To change the serpentine belt on a 2003 Pontiac Bonneville, loosen the tensioner pulley and remove the old belt. The tensioner pulley is the wheel in the belt system that has a bolt through the middle in a slot that can be adjusted. Put the new belt on and tighten up the pulley.
You will need to remove the front engine cover, on your 1997 Pontiac Bonneville, in order to change the supercharger belt. Loosen the tensioner pulley to remove the belt.
tension pulley is an automatic tensioner that keeps the serpentine belt at the proper tension it is a single pulley that is smooth (no grooves) usually turning clockwise with constant pressure loosens pulley for belt removal use caution pulley is spring loaded
If your car has a serpentine belt it will have a tensioner pulley. A tensioner pulley is easy to spot. All of your bolt on accessories i.e. water pump, alternator, a/c compressor etc. will have a pulley to run each one. There will be 2 other types of pulleys, a idler pulley and a tensioner. The idler pulley will be a single stationary pulley with a bolt going through the middle and the tensioner pulley will be on a spring loaded piviot.
I assume you mean the idler pulley on your timing assembly, if this is the case then the belt is too tight loosen tensioner pulley. if you mean the automatic tensioner pulley for your alternator and A/C and the like, the you probably need a new tensioner] Good Luck
I believe it to be on the fan belt mechanisim..the pulley that allows you to adjust the tension.
The easiest way to loosen the tensioner is to use an automatic belt tensioner. This can be used on a serpentine belt which is connected to every pulley on the engine.belt.
Google Pontiac boneville ac compressor bypass pulley. There are a few places that sell a replacement pulley that goes in the spot of the compressor that allows use of the original serpentine belt.
Or tensioner bolt if different
Loosen the tensioner pulley. Put the belt around the alternator pulley and the tensioner pulley. Move the tensioner pulley to the right until the belt is tight. Tighten the tensioner pulley.
There is a specific tool for this operation. It is a power steering pump pulley puller. This grabs the groove in the end of the pulley and pushes the punp shaft away from the pulley. Available at your parts store.
You don't. It employs a spring loaded automatic belt tensioner pulley located usually on the passenger side of the engine. If your serpentine belt is too loose, either the tensioner pulley has failed (possible, but unlikely) or the belt has stretched beyond the limits of the tensioner pulley and needs to be replaced (more likely).