answersLogoWhite

0


Best Answer

Pug 406 rad is the easiest to change that I've ever done...

drain the coolant

remove top and bottom hose clips and the thin hoseremove sensor multi plug

remove hoses

flick up clips at top of rad

lift it out!! that's it !!

replace in reverse order making sure the bottom locating pin rubber grommets are in place.

it really is that simple ..

Billy...

User Avatar

Wiki User

12y ago
This answer is:
User Avatar
More answers
User Avatar

Anonymous

Lvl 1
3y ago

How do you remove the surrounding frame

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the radiator on a Peugeot 406?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How would you remove a starter motor on a Peugeot 406 LX DT?

how do youremove a starter moto on a peugeot 406 please


How do you remove a fuel pump peugeot 406 2.0 lx petrol?

Slowly


How do you remove a driveshaft off of a peugeot 406?

This is a complex procedure, get a manual for this vehicle.


Where the hom on the Peugeot 406 2.0hdi?

WHERE THE HOM ON THE peugeot 406 2.0hdi out sade


Diagram of front suspension on Peugeot 406?

were will i get information for 1996 peugeot 406 petrol


How do you change the radiator on a Peugeot 206?

Drain the water from your radiator. Remove the top and bottom radiator hoses. Remove the radiator stabilizing bolts. Remove the radiator retaining bolts. Reverse the process to install the new radiator.


How do you change the ignition coils on a Peugeot 406?

How do you change the ignition coil on a peugeot 406 coupe?


How do you replace a heater matrix on a Peugeot 406?

not an expensive job to do. part cost about £10 but apparently it is an awkard job as a part of the dash on passengers side needs removing to get in at it. how do you remove a heater motor from a peugeot 406 do you have to remove the full dashboard or just the glove compartment


How do you remove key stuck in ignition on peugeot 406 hdi?

To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.


Why is your Peugeot 406 W reg rapier radiator and hose boiling after 5 mins on idle?

sounds like head gasket has blown


When was the first Peugeot 406 car made?

The first Peugeot 406 was made in 1995. It was made by a the French Automaker Peugot to be a family vehicle. The 406 was last made in 2003 and then was replaced with the Peugeot 407 model.


Peugeot 406 Break How can you remove the panel for replacing the rear speakers?

Undo the 12mm nut from under the speaker in the boot.