answersLogoWhite
Pontiac Montana
Radio

How do you remove the radio in a 2003 Pontiac Montana?

939495

Top Answer
User Avatar
Wiki User
2017-03-03 11:01:38
2017-03-03 11:01:38

You first have to remove two screws(7mm)in the back of the storage compartment under the pull out cup holder. Once they are removed pull that compartment out and set it off to the passenger floor side being careful not to break your lighter plug wire. Next you pull out your cup holder and remove two screws up under where the cup holder slides in and out also 7mm. Then while cup holder is pulled out remove two screws one on each side of the cup holder which are back in a little holes Phillips head. After all 6 screws are out using a small flat head screwdriver very carefully pry loose the three tabs which hold the top of the plastic trim ring above the radio. Once the trim ring is removed there are three screws that hold the radio in remove and radio is out

1

Related Questions

User Avatar

Begin by removing the radio cover in your 2003 Pontiac. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable from the back of the radio.

User Avatar

The spare tire on a 2003 Pontiac Montana is under the vehicle behind the back bumper. It is lowered from the inside using the lug wrench on the tire iron.

User Avatar

The tire locking nut on a 2003 Pontiac Montana is removed by using a special tool located in the truck of the vehicle. It meshes with the locking nut which allows it to be easily removed.

User Avatar

how to fix the light for the clock radio in a 2003 Pontiac grand am

User Avatar

The ECM is located on the driver's side, under the hood on a 2003 Pontiac Montana. It is on the driver's inner fender.

User Avatar

they are located in the exhaust system Where ? how many 02 sensors on a 2003 Pontiac Montana

User Avatar

The 2003 Pontiac Montana EGR valve is located on the firewall. The valve will be on the driver side of the firewall.

User Avatar

remove radio from a grand marquis 2003

User Avatar

how do you remove the back seat in the 2003 poniac grand am

User Avatar

Generally ,at the base of the arm is a small hinged catch that you can gently pry open. Once you do this ,the arm can be pulled off.

User Avatar

To install an aftermarket stereo in a 2003 Montana you need to first buy a trim plate or a mounting bracket. Remove the dash panel. Disconnect the ground cable from the battery. Remove the factory stereo. Unplug the factory wiring harness from the radio. Connect the new radio. Test it and reassemble the dash. Reconnect the negative battery terminal.

User Avatar

The engine fan on a 2003 Pontiac Montana works by turning on when the engine reaches a certain temperature. It then blows cool air across the radiator and engine to maintain a constant temperature.

User Avatar

The 2003 Pontiac Montana air conditioning compressor condensation drain begins on the bottom of the air conditioner compressor. The drain goes from the compressor to the bottom of the engine compartment.

User Avatar

a picture of the radio would be helpful

User Avatar

pull radio out with coat hanger

User Avatar

You don't remove the dash. You remove the part of the dash that surrounds the radio, thus giving you access to the radio.

User Avatar

mine (2003) gets about 21-25 depending on travel

User Avatar

take off trans. oil pan and you can,t help but see it

User Avatar

The proper plug is an Iridium plug, gapped at .060".

User Avatar

http://www.carstereohelp.com/strmercedes.htm

User Avatar

what you need to do is remove the panel which you will just have to pull its on by clips.The radio is screwed on so youll need a phillp to remove it.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.