How do you remove the radio in your 2003 Lincoln navigator?

Answer 1

Do yourself a favor. If you are planning to install an aftermarket radio, buy yourself a radio wiring hardness that will fit into the factory wiring hardness. It will cost under $20.00. And it will save you lost of headaches in the future. No short, or problems... _____________________________________________________________Remove Stock Ford RadioTools Needed To remove the radio you will need a "Radio Removal Tool". This is a "U" shaped pin with a dent at the end. This can be commonly found at auto parts stores or, Walmart, etc (widely available for $3-$4). The radio has two holes in each end (four holes total) · Insert the removal tool into the holes on each side (This will release the catches holding the radio into the dash) · Slide the radio toward you The Related links below gives instructions for radio removal and includes photos You can also make your own removing tool from a wire coat hanger: cut 2 U-shaped pieces (about 8" each) and insert them into the 2 holes in the front of your head unit; using a sideways motion and pulling towards you will do the trick, just be carefull when inserting the tool to not scratch the finish on the unit. I tried the wire hangar solution but went and bought the tool anyway. Either would probably work, but the tool is a bit more sturdy / stiff. Here are the instructions that come with the tool: * Disconnect negative battery wire * Insert the removal tool into the holes on either side of the faceplate * Push the tools forward about 1 inch until the retaining clips are released Grasp the tools tightly and pull apart slightly as you pull the unit from the dash.