Want this question answered?
In order to dissemble the rear axle on a 2000 Honda TRX 300 first determine if it is inner or outer joint. You then remove the retaining ring behind the boot to access the axle.
There is a complete walk through in the related links section.
loosen up the rear axle nut and loosen up the axle adjusters so the rear wheel moves forward, Now remove rear brake caliper from rear brake caliper mount and the remove rear axle and lower rear wheel and slide belt off rear pully. and remove the rear wheel. http://www.ronincycleparts.com
Check out the related links for a walk through guide.
take the pin out of the rear diffrential and the axle should come out
There's only one axle...not a left and right. Buy a Honda service manual before you tare it up.
how to remove rear axle from 1988 f250 ford
4 flange bolts behind hub and you will need a slide hammer to remove the axle!
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
Jack up the rear of the quad (put a milk crate under it). Remove both wheels. Remove the chain. Apply the rear brake and loosen the nuts on the axle (right side). Remove the brake caliper & bracket. Remove the circlip, nuts and rotor. Slide the axle through the bearing carrier, from right to left (towards the chain and sprocket side
Block up the ATV with the rear end off the ground. Remove both rear tires. Remove the brake assembly(brake drum, etc). Should be two locking nuts that hold the axle in place. remove those nuts. Axle slides out the passenger side
98 accord does not have a rear axle- just spindle/hub/bearing