Want this question answered?
The best way to remove the rear axle on a Polaris Hawkeye is to spray it with PB blaster. After waiting several hours or a day, simply pull the axle outward.Ê
Polaris Sportsman 500 X2 Cectek T5 ix d Cectek T6 ix d
buy the clymer manual first. there are clips on the inside of the cups remove them press the Ujoint out of the yoke. someone told me you need to install the rear drive shafts with the yokes/u joints the same on both sides lined up. Mine were from the factory. thanks
2005 Polaris Sportsman 500 HO. Front tires are 26x8x12, Rear tires are 26x11x12
remove axle bolt from spindle and push it through you may have to remove spindle if no clearance. remove factory tie strap clean and grease before replacing with new boot reassemble in reverse watch for pin on nut threads reversed on passenger side always consult technical manual and follow safety protocols
how to remove rear axle from 1988 f250 ford
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
yes at the bottom turn it clockwise to stiffen
Place a support under the rear swingarm. Remove the right rear wheel and tire assembly. Then remove the dust cover from the end of the axle. This will exposes the end of the axle, with a castle nut and cotter pin. Push the cotter pin out of the castle nut. Remove the nut from the end of the axle. After removing the nut, gently tap on the rear of the spindle, until it slides off of the axle. Then remove the three bolts securing the chain guard to the sprocket. To loosen the chain, you will either have to remove the master link, or adjust it to a looser setting. Remove the chain after loosening it. Three more bolts hold the sprocket in place on the hub assembly. Remove them, and slide it off of the axle.
There is one on each rear axle and one on each front A-Arm. Also there is a hard to reach one behind the rear brake pedal. You may have to roll the ATV back and forth until you find it. I hope this helps.
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
loosen up the rear axle nut and loosen up the axle adjusters so the rear wheel moves forward, Now remove rear brake caliper from rear brake caliper mount and the remove rear axle and lower rear wheel and slide belt off rear pully. and remove the rear wheel. http://www.ronincycleparts.com