How do you remove the rear bumper from a Toyota Corolla?
For 2005 Corolla (may fit Corolla 2001 - 2005)
1/ 4 mm slot screwdriver
2/ #1 Philip hear screwdriver
3/ 10 mm socket and 1/4" drive
4/ 10 mm deep socket
5/ 6" 1/4" drive extension.
1/ Remove spare wheel cover assembly
2/ Remove rear floor finish plate by:
a/ remove the 3 clips
b/ use a screwdriver to pry out the rear floor finish plate carefully.
3/ Remove the luggage compartment trim cover inner LH by remove 4 clips.
4/ use same manner to remove the luggage compartment trim cover RH.
5/ Disconnect the rear bumper side seal LH.
6/ Disconnect the rear bumper side seal RH.
7/ Remove the rear bumper cover by removing
a/ 4 nuts with 10 mm deep socket
b/ 2 screws inside the bumper cover
c/ 6 clips at the bottom of the bumper cover
d/ Disengaged the hooks and remove.
Instructions Lift the rear of the Corolla using a floor jack. Jack up on the rear jack point behind the trunk, and place a jack stand under each of the rear pinch welds. Then lower the vehicle onto the jack stands. Pry the plastic rivets off the inner wheel liner with a flat-head screwdriver. Remove the bolts that hold the bumper to the bumper bracket and support. Pull the bumper off the bumper support. Mount…