To remove the rear door inner panel on a 2003 Subaru Outback, start by removing any screws securing the panel, typically found near the door handle and at the bottom edge. Next, carefully pry off the panel using a trim removal tool to detach the clips holding it in place. Once loose, disconnect any electrical connectors for window controls, and gently lift the panel off the door. Be sure to handle the panel carefully to avoid damaging clips or the panel itself.
Go to this link...it steps you through the process very nicely. http://bodyshopzone.com/archives/trim/door_panels/Subaru/Outback_2007/remove_dp_07_Outback.html
Check out this site: http://www.bodyshopzone.com/archives/trim/door_panels/Subaru/Outback_2001/remove_fr.html
How do I replace the rear wiper motor or just remove the rear panel on the back window to see if my rear wiper motor is unplugged on my 2007 Subaru Outback? Thanks!
To remove the rear hatch door panel in order to fix the lock on a Subaru Outback you will need a Phillips-head screwdriver, small flat screwdriver, trim pry tool, and tack puller. Using these items you need to remove the push clips and pry the trim from the hatch.
Remove Glove Box & Access Panel. Disconnect Blower Motor Electrical Plug & Aspirator Hose. Remove screws & Motor. Install in reverse order.....
Has a starter relay in the engine bay fuse panel.
Open hood panel and prop with rod. Remove screw at headlamp that holds signal lamp. pull lamp straight forward. remove and replace bulb
To remove the blower motor from a 2005 Subaru Outback, first, disconnect the negative battery terminal for safety. Then, remove the passenger side lower dash panel and the glove box to access the blower motor housing. Disconnect the wiring harness from the blower motor, remove the retaining screws, and carefully take the blower motor out of the housing. Finally, replace it with the new unit, reversing the steps to reassemble.
In a 1997 Subaru Outback, the fuel pump is located inside the fuel tank. To access it, you'll typically need to remove the rear seat and the access panel or, alternatively, drop the fuel tank itself. It's important to relieve the fuel system pressure before attempting any repairs or replacements.
The Emergency Killswitch in the Subaru Outback is located underneath the drivers-side steering panel. It is to the left of the steering column and looks like an inconspicuous button. Just press that with the keys in the ignition and with the electricity on.
To fix the rear wiper motor on a Subaru Outback, first, ensure that the issue isn't with the wiper switch or fuse. If those are functioning properly, access the motor by removing the interior trim panel on the rear hatch. Disconnect the wiring harness and remove the motor's mounting bolts, then replace the faulty motor with a new one. Reconnect everything, test the wiper, and reassemble the trim panel.
To change the 4-way flasher switch on a Subaru Outback, first, disconnect the battery to ensure safety. Then, remove the trim panel surrounding the switch by gently prying it off with a trim tool. Next, unscrew and pull out the old flasher switch, and replace it with the new one by reversing the process. Finally, reattach the trim panel and reconnect the battery to test the new switch.