answersLogoWhite

0


Best Answer

Removing the rear fender from a 2007 Vulcan 900 is not hard at all. Simply remove any screws or fasteners and wiring that are holding the fender in place. There are tutorials for removing the fender online at YouTube.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the rear fender from an 07 vulcan 900?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Change the battery on a Kawasaki vulcan 900?

remove seat. remove tool case. Remove terminals from battery, lift out.


Are Kawasaki 900 z1 compatible with a vulcan Kawasaki 900?

No not at alll


How many gears does your 900 vulcan have?

speeds


What Oil does a Vulcan 900 use?

MOTOR OIL lol


What is quarter mile time for Kawasaki vulcan 900?

9.9


What type of gas mileage does a Kawasaki vulcan 900 classic get?

I have a 2007 Vulcan 900 and I got only 125 miles off a tank of gas. I was on the hwy and driving between 75-80 mph


How do you remove the seat on a Kawasaki Vulcan?

There are a couple of screws. At least on my 500 On my '99 Vulcan 800 there is one bolt in the rear of the seat. Remove that and then pull the seat toward the rear to release the retaining clips. On mine it takes a bit of force so I use the rear rider foot pegs for leverage (be careful not to fall backwards when it breaks loose!) -------------------------------------------------------------------------------------- Rule 1: Ask a clear question. There is a 500, 750, 800, 900, 1600, 1700, 2000, Nomad, Voyager, Mean Streak, Classic, and more, and removing the seat varies among them. My addition to this answer is for a 1992 VN750. Open the small trunk on the seatback and remove the two 10mm bolts. Seat lifts rearward and up. This should be the same for most model years.


Where is the fuse box on a Kawasaki Vulcan 900?

It's under the left side cover. Take the seat off and remove one screw and then the side cover pulls right off.


Need to change the oil in your kawaski vulcan 900 classic how many quarts dose it take?

It takes almost exactly a gallon. Just did my oil change on a 2006 Kawasaki Vulcan Classic 900. It was just over a gallon, but a gallon worth was good enough.


Can i take out baffles on 2007 vulcan 900 classic?

yes look herehttp://people.delphiforums.com/vstarlaz/knowledgebase.htm#Exhaust


Recalls on Kawasaki vulcan 900?

all us recalls can be found on http://www-odi.nhtsa.dot.gov/recalls/recallsearch.cfm


Where is Kawasaki Vulcan Classic engine number located?

Look into the space between the exhaust pipes on the right side of the bike at the rear of the engine. The engine number is stamped on the side of the engine block at the bottom. ('09 Vulcan 900 Classic LT) On a 2000 1500 Vulcan Classic. It's stamped on the *left* side of the crankcase - on the kickstand side. It's between the frame and the crankcase so you need to view it from an angle; looking from the front. Wipe it clean first and and bring a flashlight...