and bottom of the cluster housing - these are exposed when you open the boot lid. You will see carpet overlain by a plastic trim piece running up from the boot floor toward the area to the side of the light cluster. The plastic is held by a single screw toward the rear end of the vehicle - undo this screw. Now, using a flat blade slide under the plastic and over the top of the carpet trim and prise the carpet to the front exposing enough room to get your hand under the plastic and behind the light cluster. You will see (or feel) a plastic wing nut which needs to be loosened and removed. Its head is about 1 inch in diameter and it takes 15 to 20 turns to loosen. Do not drop it inside the void!!!
Pull the whole cluster away from the rear of the car then unclip the bulb housing from the plastic ouetr casing (2 grey/white clips). Change the bulb(s) as required. Re clip the bulb hosing into the rear of the glass then push the glass back into place using the 2 locating pins on the outer flank. Holding the housing, carefully replace the wing nut till finger tight, tuck the carpet trim back under the plastic and screw down then finally replace the 2 outer screws.
How do you remove the bottom front right airbag on a 2011 ford fiesta.
How do you remove the dashboard on a 1996 Ford Fiesta
remove the light assy from the car.
You can change the rear lights in your 2009 Ford Fiesta by removing the interior panels behind the tail lights. Push the light clip and turn it. the light will pull out to be replaced.
In the wifes Zetec its in the boot inside the offside panel just to the side of the light cluster access, if you getb were i mean.
Remove the instrument cluster.
removel of door panal in ford fiesta 2002
DIMMER SWITCH OR WHAT?"How_do_you_remove_instrument_cluster_on_98_Ford_Ranger_to_replace_cluster_bulb"My 1995 Ford Ranger dashboard is dark, the control to the cab light is operational. I have installed a JVC Stereo with is the only light I have on the dashboard. Do I need to remove the steering wheel to get to the components of concern?
It was a this time that Ford changed the rear styling from a light cluster with squarish styling to a cluster with a round indicator lamp. The two are the same shape but the earlier one was held in with a big plastic wing-nut on the inside, whilst the later one has two T25 Torx screws.
The front for the light, on your Ford fiesta, can be changed by locating the fourth light connector on the back of the light. Push the connector in and turn at the same time. The fog light will come out.
There are several reasons why a warning light may be on in a Ford Fiesta. Some reasons could be brakes, loose gap cap, or even low fluids.
Remove 2 7mm bolts on instrument cover plastic. remove this part exposing the 4 7mm bolts that hold in the cluster then carefully remove instrument cluster from dash. On the back of the cluster you can remove the bulbs by turning them counter clockwise and pulling them out. Bulb number 194